You asked: Can you use a bead reamer on glass beads?

What do you use a bead reamer for?

A bead reamer is a pointed, round file that is used to either smooth the edges of the drill hole in a bead or to widen the hole itself. Its important to always smooth the rough edges on a bead as they will wear the cord or wire of your design.

How do you widen beads without a reamer?

You don’t have to purchase a bead reamer. A few things you can use: a safety pin, a toothpick, a paper clip or bobby pin, darning needle, anything with a point that will slide through the beading hole easily.

How do you file glass beads?

Begin rotating and filing the inside of the bead hole. Do not put the reamer into the hole to the point where it becomes tight. This may cause the edges of the bead to chip or the bead to break. File until the bead hole feels smooth, rewetting the reamer and the bead from time to time.

How do you enlarge a bead hole?

Dip natural beads, such as pearls and beads made from precious stones, in a bowl of water. The purpose of the water is to minimize heat friction, which increases your chances of cracking the bead, as you begin to drill a larger hole. You will continue to hold the bead under the water as you widen the hole.

IT\'S FUN:  You asked: What kind of art is Mosaic?

Can I make my own glass beads?

Learning to make your own glass beads for your jewelry projects doesn’t have to be a daunting or expensive task. You don’t need to buy a kiln, propane, torch, etc. to make your own lampwork glass beads. … In most cases, you have to take an introductory glass/flameworking class before you can access the open studio hours.