How do I fix the tension on my Brother sewing machine?

What should the tension be set at on a Brother sewing machine?

The normal tension setting is 4.0. The upper thread and the bobbin thread should cross near the center of the fabric. Only the upper thread should be visible from the right side of the fabric, and the bobbin thread should be visible from the wrong side of the fabric.

How do you adjust the tension on a Brother sewing machine?

Turn the thread tension dial to a lower number (toward the left). (Loosen the thread tension.) When the upper thread is visible from the lower side of the fabric. Turn the thread tension dial to a higher number (toward the right).

Why can I get the tension right on my sewing machine?

When sewing fabrics together problems can occur when the thread tension is not correct, the needle or bobbin is not inserted properly, or the machine is not threaded correctly. … Check you have chosen the right needle size and thread to suit the fabric type and weight.

Why is my thread bunching underneath?

A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.

IT\'S FUN:  Can I wash a quilt that says dry clean only?

Why Does My Brother sewing machine keep jamming?

The tension could be too tight or too loose. Set the tension to the basic thread tension setting or adjust the tension manually. The combination of the needle size, thread size and fabric is incorrect. Be sure to use the correct size needle and thread for the type of fabric that you are sewing.

What tension should my sewing machine be on singer?

The target figure should be around 30 to 40g. (1-1/4 to 1-1/2 oz) but it does not have to be too precise. However most people don’t have a spring balance handy, so alternatively you can tie a weight of the correct amount onto the thread and then jerk the bobbin gently upwards.