Why won’t my sewing machine pull up the bobbin thread?
– Your thread could be caught on something between the needle and your spool of thread if so, your thread will be too tight for the needle to pick up the bobbin thread. – Make sure that the upper thread is threaded properly. … The flat side of the needle should be facing toward the back of the machine.
Why is my thread bunching underneath?
A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.
How do you fix bobbin tension?
Bobbin tension or bottom tension is fixed by adjusting a small screw next to your bobbin case’s thread opening.To adjust, use a tiny screwdriver and turn the tiny screw to the right for tighter tension or the left to loosen bobbin tension.
How do I know if my sewing machine timing is off?
If your hook tip is passing through or below the needle eye, then the timing of the sewing machine is off. On the other hand, if the hook tip is passing above the needle eye, but extends past the needle more than a couple of millimeters when the needle eye meets the radius of the hook, then the timing is also off.
How do I know if my bobbin tension is correct?
The thread should unwind just slightly and the bobbin case should drop an inch or two. If the thread unwinds without resistance and the case slips to the floor, your bobbin tension is too loose. If the bobbin case doesn’t budge, your bobbin tension is too tight.