How do I fix the Zig Zag on my Janome Sewing Machine?

How do you fix the zigzag stitch?

Try some of the simple things first. Remove the bobbin plate using a screwdriver and then remove the bobbin. Clean out any lint that may be under the bobbin and which may cause your zigzag stitch not to work. Replace the bobbin and the bobbin plate and test your zigzag stitch.

Why is my zigzag stitch not working?

Explanation: When the thread loops on the backside of the fabric, that’s an indication the upper thread is not threaded correctly. The thread is not receiving the tension it needs. This could be because it was not threaded correctly or the tension needs to be adjusted.

What tension should I use for zigzag stitch?

The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing. This should be suitable for most fabrics. If you are doing a zig-zag stitch, or another stitch that has width, then you may find that the bobbin thread is pulled through to the top.

Why won’t my sewing machine go up and down?

A disengaged clutch, broken drive belt or internal drive gear failure can prevent the needle from moving. Engage the hand wheel clutch if you have it disengaged for bobbin winding. If the drive belt is okay, an internal drive gear failure is likely preventing the needle from moving. …

IT\'S FUN:  When did Lilo and Stitch come out?

Why are my stitches not catching?

Skipped stitches can mean one of two things: needle issues or disrupted timing. First, your needle may be dull or damaged and needs to be replaced. You should also check that you are using the correct needle for the type of fabric you are sewing.

What setting should my sewing machine be on?

Most sewing is done in the 2.0 to 2.5 range. If you are foundation paper piecing, you may want to decrease your stitch length so that the paper tears away easier. Top stitching and quilting are usually done in the 3.0 to 3.5 range. Basting and gathering stitches are the longest, from 4.0 – 5.0.

Why is my bottom stitch not straight?

If your thread is pulled tight on the underside and not forming an even stitch then (counter-intuitively) it’s usually the top thread tension that’s wrong. Sometimes very lightweight fabrics such as sheers can get dragged down into the machine so it’s a good idea to use a straight stitch plate.

Why is my machine sewing gathers?

Tension pucker is caused while sewing with too much tension, thereby causing a stretch in the thread. After sewing, the thread relaxes. As it attempts to recover its original length, it gathers up the seam, causing the pucker, which cannot be immediately seen; and may be noticeable at a later stage.