Why is my bobbin stuck?

Why does the bobbin keep getting stuck?

This can be caused if the top thread tension is too tight, or if the bobbin thread is not in the bobbin case tension. … Make sure the bobbin is correctly seated in the bobbin case (bobbin holder), and check that the upper thread tension is not set too tightly.

Why is my bobbin stuck on Winder?

Check that the thread didn’t wind underneath the bobbin winding disc. – This could cause the bobbin to stay stuck. 3. Try unwinding the bobbin to see if it will allow you to take the bobbin out.

Why can’t I pull the bobbin thread up?

First, make sure the bobbin-winding spindle (located on top of your machine) has been pushed back to the left for sewing. If it is not in the correct position, the needle will not go down and pick-up your bobbin thread. … Make sure the presser foot is up when seating the thread through the upper tension.

How do you fix a sewing machine that will not move?

Engage the hand wheel clutch if you have it disengaged for bobbin winding. If the needle won’t move with the clutch engaged, unplug the sewing machine and check the drive belt. Replace the drive belt if it’s broken. If the drive belt is okay, an internal drive gear failure is likely preventing the needle from moving.

IT\'S FUN:  What is raised embroidery?

How do you unjam a sewing machine?

Raise the needle to the highest position using the hand wheel. If the needle will not move, gently work the hand wheel back and forth a little bit to see if the needle loosens. If it just won’t move, don’t worry; move on to Step 4.

How do you get a stuck bobbin off a bobbin winder?

Cut the thread with scissors beside the bobbin-winding thread guide. Slide the bobbin winder shaft to the left, and then remove the bobbin from the shaft. Hold the thread end with your left hand, and wind off the thread clockwise near the bobbin with your right hand as shown below. Wind the bobbin again.