What are the terms for weaving?
- Selvage: The woven edge of a fabric. …
- Shed: The opening created on a loom where the weft passes.
- Tabby: Plain weave and ground weave for a pattern weave. …
- Sett (also epi / ‘ends per inch’): The number of warp threads per inch.
- Threading (drawing in): Drawing the warp threads through the eyes of the heddles.
What are ends and picks in weaving?
In general, weaving involves using a loom to interlace two sets of threads at right angles to each other: the warp which runs longitudinally and the weft (older woof) that crosses it. One warp thread is called an end and one weft thread is called a pick.
What is the fell in weaving?
Fell Where the last laid weft pick is pressed into place. The fell line advances at the weaving advances. Header Waste yarn that is woven at the beginning of a project to spread the warp to its full width and to provide a firm even surface to start your weaving.
What are the strings on a loom called?
Note: The strings across your loom are called the warp. This is the foundation of the weaving. The threads that cross the warp are called the weft.
Which weave has maximum warp float?
Orthogonal weave architecture is used to make thick panels or structures as shown in Figs 9.14, 9.15, and 9.16. The maximum number of warp fibers (X fibers), picks (Y fibers), and Z fibers can be inserted because of the lack of interlacements.
Is the thicker fabric ribbing in the weave?
Rib Weave Manufacture
This is used for either the warp of weft yarns and the end result is a fabric that has raised ribs either horizontally or vertically down the fabric, depending on whether the heavier, thicker yarn is used for the warp or the weft.
What is the shuttle on a loom?
Shuttle, In the weaving of cloth, a spindle-shaped device used to carry the crosswise threads (weft) through the lengthwise threads (warp). Not all modern looms use a shuttle; shuttleless looms draw the weft from a nonmoving supply.